One. Main Parameter

Product Standard Structure:  Anti side leakage N.W., Top-sheet N.W., Conductive layer, Core (Lower N.W.+ (Eight-shaped cotton core  & SAP )+ Small cotton core & SAP) +Upper N.W., bottom film,Lamination N.W., Elastic waist, Front waist tape, Left and right waist tape (ordinary PP), Three-dimensional protective rubber band +leg rubber

(1)Design Speed:350pcs/min

(2)Stable Speed: 250pcs/min

(3)Distribution of raw materials: the surface absorption layer is on the top and the bottom film is on the bottom;

(4)With Double Core;

(5)With Auto splicing and Auto Reject;

(6)Glue applicator: About 7 sets;

(7)With Wetness indicator;

(8)With PLC & Touching Screen;

(9)With 4 sizes, S,M, L,XL;

(10)Frontal with position cutting;

(11)Product gram weight deviation: ± 8%;

(12)Product yield: ≥ 96%;

(13)Machine size: 40m*7m*4m(L*W*H);

(14)Machine Power: About 420KW;

(15)Gas supply pressure: 0.6-0.8mpa;

(16)Electrical supply: 380V ± 5%, 50Hz three-phase four wire + grounding wire.

Two.Mechanical configuration and features

1.Drive system features:

(1)The whole machine is driven by servo motor, and the number change only needs to be adjusted on the touch screen

(2)Widen the synchronous belt under heavy stress to minimize bridge crossing

(3)Rear transmission with exhaust window and observation window transmission control

(4)Single-button sequential start to reduce grid impact

(5)The production line cannot be started if the fan is not started, the melter is not ready, the air pressure is low, etc., but the above functions can be shielded on the operation screen, which is convenient for empty machine debugging;

2.Detection system:

(1)Automatic detection and arrangement of raw material joints

(2)There are sound and light alarms or shutdowns when raw materials are cut off

(3)Polymer low level detection, low level alarm

3. Unwinding and splicing:

(1)Stable unwinding during splicing, automatic splicing or manual button splicing

(2)The splicing speed can be set separately on the operation screen

(3)The roll diameter can be adjusted precisely when the raw materials are spliced, saving raw materials